HOW TO USE THE AUTOMATIC DECOILER TO FEED MATERIAL

HOW TO USE THE AUTOMATIC DECOILER TO FEED MATERIAL

How to use the automatic decoiler to feed material?

1.Uncoiler has been set to standard in our factory: When metal coil strip touches the sensor rod, machine will stop at once. When coil
leaves the sensor rod for a few minutes (sensor time), the machine will start to work. www.hongerjixie.com

2.The Sensor time set short or long affects to the operating and service life for machine. You can adjust the sensor time on the control box. Returning the Knob can set the time you need. We set 3 seconds in the factory. The speed of straightener should correspond
3.If uncoiler speed can not match with the press speed, you should see if the uncoiler speed reach the press speed. If uncoiler speed 

ease see if the sensor time is too long or contact supplier.

Super Version Uncoiler

Super Version Uncoiler

Some of our Europe Clients Request Super high quality uncoiler .

To meet they requipment, we research below new Super version uncoiler.

Super MT-500

Material width : 500mm

Max. Weight: 3T

Maxt Thickness :3.2mm

Hydraulic expansion

(Remark: This quality is Super Good but the price a little high than common uncoiler)

Honger Machine GL Series 2 IN 1 Decoiler Straightener Is Ready For Delivery

GL Series 2 IN 1 Decoiler Straightener Is Ready For Delivery

GL series 2 in 1 decoiler straightener is ready for delivery.

This GL series is for thickness 0.3~3.2mm,
Coil I.D. 508mm,
O.D.1200mm.

Naked dimension of this machine is about 2350mm*1350mm*1500mm,naked weight is about 1000kg.

2 in 1 decoiler straightener Picture is as below in our workshop: